VQT4L45
23
Changing the main unit and remote control mode
About USB device
-
Please read these instructions when connecting
an USB device.
- This unit supports less than 10Mbps High
Speed.
-
When connecting or disconnecting USB device
please adjust the volume to minimum.
- This unit only connects an USB device once.
Don’t try to use USB hub.
-
This unit cannot recognize the USB device over
5V/500mA rated value.
-
This unit subjected to the electrostatic
interference when connecting the USB device
may cause playback abnormally. In this case,
please disconnect the USB device
fi
rst, then
reset the unit and the USB device.
-
This unit can connect the USB device that
conform to USB speci
fi
cation and DAP (Digital
Audio Player).
-
Some DAP is not compatible with this unit.
- This unit cannot play the copyright protection
tracks.
- This unit cannot play the tracks being coded
with special method or being encrypted.
-
When connected to the USB port of this unit
you can charge the USB device.
-
When playing back the
fi
les in USB device, never
disconnect the USB device. So doing, it will
cause damage of the unit and USB device.
-
This unit can play the MP3/JPEG
fi
les in USB device
(Maximum data transmission rate: 320kbps).
-
This unit may not play back some
fi
les in USB
device even if their formats are listed before
(page5).
-
When playing back the
fi
les with large
transmission rate, the picture or sound may be
lost during playback.
-
Some USB large capacity storage device may
not be recognized and work normally.
-
For the data losing during playback of the
USB large capacity storage device will not be
responsibility.
It is possible to affect the unit when operating the
remote control of other product. At this moment
please change the remote control mode.
Factory default setting is “REMOTE 1”.
Change the unit to “REMOTE 2”
1. In
power on mode, select MUSIC P..
2. Press and hold the
n
button on the main
unit and 2 button on the remote control
simultaneously for at least 2 seconds.
“REMOTE 2” appears.
Change the remote control to “REMOTE 2”
3. Press the 2 button and OK button on the
remote control simultaneously for at least 2
seconds.
Confi rmation the action
If the remote control can operate, the setting is
correct.
If the remote control can not operate please
change the remote control in accordance with the
display on unit.
Example: The “REMOTE 2” displays on the unit,
please operate step 3 above.
Return the remote control to “REMOTE 1”
(1) In step 2 above press and hold the
n
button
on the main unit and 1 button on the remote
control simultaneously for at least 2 seconds.
“REMOTE 1” appears.
(2) Press the 1 button and OK button on the remote
control simultaneously for at least 2 seconds.
