RQT9478
9
Installing and assembling the rack
Connection
Setting the caster trays
Wire dressing cover assembly
Set the caster trays under all 4 casters to
fi
x
this system and prevent it from moving.
• When setting the caster trays, match the caster cover with the
arrow of the caster trays as illustrated below.
• At least 2 people are necessary for setting the caster trays.
Be careful not to catch your
fi
ngers.
• Lift the rack to remove caster trays. See page 7 about how to lift
the rack.
(Caster direction)
Make the direction of front and back casters inward so
the caster trays do not run out.
1 Collect cables
connected to each
equipment.
• For connections with other
equipment stored in this
system, refer to “Home
Theater connections”
(
➜
pages 10 to 13).
• Pull the cables of equipment
on the shelf board out of the
wire dressing hole.
2 Match the end
of wire dressing
cover with the wire
dressing case.
• Match the
fi
xing hole of
wire dressing cover with the
protrusion of case.
• The wire dressing cover
does not have directions.
3 Match the other
end, press and set
it until it clicks.
• If the wire dressing cover is
misaligned, move it up and
down to align the position.
To remove
• Press and hold the end of
the wire dressing cover to
remove.
inward
outward
(Rear
view)
Wire
dressing
hole
Fixing hole Protrusion
Wire
dressing
case
Wire
dressing
cover
Click
Cover
Caster tray
Arrow
Stabilising the television
Attach the television to the rack to prevent it from falling over.
Fixing to the rack
• Make sure to use the supplied fall-prevention screw to attach the fall-
prevention band etc. as illustrated at right. (If the fall-prevention band
is not supplied with TV, use a commercially available band to
fi
x.)
Attach the fall-prevention band to the prepared hole at the back
bottom of the rack.
• When you attach the fall-prevention band supplied with the TV, follow
the operating instructions for the TV.
Prepared
screw hole
Fall-prevention band
Screw (included)
(Setup example)
• If you fasten the screw too tightly, it goes around in circles and
the TV cannot be
fi
xed.
• Make sure to use the fall-prevention screw supplied with this
system.
Note
The illustration is an example.
The shape may differ from the actual product.
