Getting started
Precautions
RQT9834
11
Place the main unit in the desired position and attach each cord onto the
rack or table.
≥
Make sure that the slack of the cord is minimal.
Supplied components
Commercially available components (not supplied)
≥
Screws for wall mounting...................................................................................................................
k
4
≥
Fall prevention cord ...........................................................................................................................
k
2
≥
Screw eyes (to attach the fall prevention cord) .................................................................................
k
2
≥
Use commercially available screws with a nominal diameter of 4.0 mm, which are suitable to the material of the wall (e.g., wood,
steel, concrete, etc.) and are capable of supporting over 33 k
g
.
≥
Use a cord that is capable of supporting over 33 k
g
(with a diameter of about 1.5 mm).
Locate the screwing positions on the wall.
≥
Use the measurements indicated below to identify the screwing positions on the wall.
≥
Position the main unit with at least 50 mm of space above it. If not, it may not be possible to access the buttons.
≥
The position on the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 k
g
.
≥
Be sure to use a spirit level to ensure that both screwing positions are horizontal to each other.
G
Screw eye
≥
Attach at a position capable of
supporting over 33 k
g
.
≥
Depending on the placement of
the main unit, the screwing
position of the screw eye may
differ.
When attaching the main unit to a wall
∏
4 Safety holders
∏
2 Wall mount brackets
∏
2 Rear pads
∏
2 Screws with
washer
∏
2 Screws without
washer
A
Wall mount bracket (supplied)
252 mm
257 mm
233.5 mm
275.5 mm
1018 mm
75 mm
31.5 mm
43.5 mm
12.5 mm
A
A
SC-HTB527EGEB_RQT9834-B.book 11 ページ ２０１２年１２月１０日 月曜日 午前１１時２９分
