Getting started
RQT9690
17
Connect the speaker cables.
≥
Insert the wire fully, taking care not to insert beyond the wire insulation.
≥
Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with
the speaker cable with a white connector on the observers’ left.
To prevent the speakers from falling, it is recommended, as an additional
protection measure, to attach the speakers to the wall or table with a fall
prevention cord (hereafter “cord”).
≥
Consultation with a qualified installation specialist concerning the appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support is recommended (
>
11, 13). Improper attachment may result in damage to
the wall and speakers, and personal injury.
≥
Use a cord that is capable of supporting over 10 k
g
(22.05 lbs) (with a diameter of about 1.5 mm (
1
/
16
q
)).
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Make sure that the slack of the cord is minimal.
Additional speaker fall prevention measures
When attaching the speakers to a wall
A
Cord
§
B
Screw eye
C
Wall
D
Wall-mounted speakers
§
If the cord cannot be threaded through the holes, try bending the cord in 2 locations, about
10 mm (
13
/
32
q
) apart from the tip, at an angle of 45
o
(as
illustrated above).
Insert the
wire fully.
r
: White
s
: Blue line
Press into the groove.
Push
Back of the base
Horizontal placement
Vertical placement
SC-HTB450_RQT9690_mst.book Page 17 Tuesday, March 6, 2012 2:17 PM
