9
RQT6850
Change the cut-off for bass
output from the front speakers
If you set the front speakers to “SMALL”,
the filter is set to 100 Hz.
Raise the cut-off if the bass from the front
speakers is unsatisfactory so the bass is
output through the subwoofer.
You can raise the cut-off from 100 Hz to
either 150 Hz or 200 Hz.
Adjusting speaker output
level
Adjust the level of the other speakers based on the
output of the front speakers.
(Adjust the volume of the front speakers with [VOLUME].)
C (center), SR (surround right), and SL (surround left)
can be adjusted between –10 dB and +10 dB, with
0 being the level of the front speakers.
Adjust center and surround output to the same apparent
level of the front speakers.
For SW (subwoofer), you can select “---” so there is no
output, “MIN” for minimum output, a level between 1 and
19, or “MAX” for maximum output.
Adjust subwoofer output so it is balanced with the front
speakers.
Subwoofer output is easily influenced by the source. You
can also change its level while playing something for
better effect.
Preparation: Turn SPEAKERS on.
3
5
Change the setting.
Select.
Output the signal.
Adjust the main volume.
Adjust the level.
Stop the test signal.
Repeat.
FILTER
Two seconds each.
Select the speaker
channel.
Change these settings to suit the
connections you have made to the three
digital input terminals, COAX, OPT 1 and
OPT 2, so that the correct source is
selected when you turn [INPUT
SELECTOR].
The factory settings are:
CD:
COAX
DVD:
OPT 2
TV:
OPT 1
4
D-INPUT
Digital input
Select.
Change the setting.
Repeat.
TEST
L
C
R
SR
SL
SW
Speakers set as “NONE” or “NO”
are skipped.
TEST
VOLUME
+
–
Select the input.
+
–
LEVEL
Repeat these steps for each speaker
channel.
Repeat these steps for each input.
Change the settings to suit your speakers and units to the environment in which you are using them. Before making any changes, read the
descriptions of the settings, note the factory settings and ranges, and refer to the equipment’s instructions.
Step 3