![background image](http://html.mh-extra.com/html/panasonic/pt_at6000e/pt_at6000e_operating-instructions-manual_270757080.webp)
[OPTION] menu
80 - ENGLISH
Settings
•
[BLANK]
When [BLANK] is activated, output is 12 V. If the
setting is released, output is 0 V.
•
[RS-232C COMMAND LINK]
Receives commands (
page 103) from external
device and outputs 12 V.
z
Input
[POWER ON/OFF]
[BLANK]
•
[POWER ON/OFF]
If the trigger input signal from the external device is
changed from 0 V to 12 V, the projector power will be
switched on. And if it is changed from 12 V to 0 V, the
power will be switched off.
•
[BLANK]
If the trigger input signal from the external device is
changed from 0 V to 12 V, the screen will go blank. And
if it is changed from 12 V to 0 V, the [BLANK] setting
will be released.
3) Press the ▲▼◄► buttons to move the
cursor to [DELAY TIME]
4) Press the ◄► buttons to set the delay
time for the trigger output signal
z
The delay time can be set to 2, 4, 6, 8, 10, 20, and
30 seconds.
z
It is possible to delay the trigger output signal (12 V)
by the amount of time set. (Only available if trigger
output item is selected.)
E.g.) Select [SELECT 4:3 ASPECT] of the trigger output
function and set the delay time to 10 seconds.
Set the [ASPECT] in the [POSITION] menu to [4:3],
and 12V is output from the trigger port after 10
seconds.
Note
z
You should not use trigger terminal output as the power
source for other devices.
z
The projector will not accept trigger input while preparing
to project after the power has been switched on and
while preparing to shutdown after projection. Input trigger
signals after projection starts or after entering standby
mode.
z
12 V cannot be output from the trigger terminal when the
projector is in standby mode.
[SLEEP]
Set the time for the power to be automatically turned
off.
Switch settings
Switch settings
[OFF]
Inactive
[60MIN.]
Turn power off after 60 minutes
[90MIN.]
Turn power off after 90 minutes
[120MIN.]
Turn power off after 120 minutes
[150MIN.]
Turn power off after 150 minutes
[180MIN.]
Turn power off after 180 minutes
[210MIN.]
Turn power off after 210 minutes
[240MIN.]
Turn power off after 240 minutes
Note
z
The projector automatically enters power off preparation
mode (the power indicator illuminates orange), and then
enters standby mode (the power indicator illuminates or
flashes in red). (
page 28)
z
3 minutes before turn-off, the number of minutes
remaining will be displayed in the lower right corner.
z
If [SLEEP] mode is set to [OFF] mode before the
specified time has elapsed the settings are erased.
[HIGH ALTITUDE MODE]
Set to [ON] when using at locations between 1 400 m
(4 593 ft) and 2 700 m (8 858 ft) above sea level.
Switch settings
Switch settings
[OFF]
When using at an altitude of less
than 1 400 m (4 593 ft) above
sea level
[ON]
When using at high altitudes
(between 1 400 m (4 593 ft) and
2 700 m (8 858 ft) above sea
level)
Note
z
The fan rotation and operating noise increases if set to
[ON].