Note
f
The [COMPUTER2 SELECT] will be unavailable when [COMPUTER2] is selected as input source.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable
simultaneous control or individual control via a single remote control.
1) Press
as
to select [PROJECTOR ID].
2) Press the <ENTER> button.
f
The [PROJECTOR ID] screen is displayed.
3) Press
as
to select a projector ID.
f
To select one item among [ALL] and [1] ~ [6].
[ALL]
Select when controlling projectors without specifying an ID number.
[1] ~ [6]
Select when specifying an ID number to control individual projector.
4) Press the <ENTER> button to set it.
f
[PROJECTOR ID] is set.
Note
f
To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f
When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or
computer control.
If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors
with other ID numbers.
f
Refer to “Setting the ID number of the remote control” (
Æ
page 50) for how to set the ID number on the remote control.
[INITIAL START UP]
Set the method of start up when the power cord plugged into the AC outlet.
1) Press
as
to select [INITIAL START UP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[LAST MEMORY]
Starts in the condition that before disconnected the power cord or turn off the breaker.
[STANDBY]
Starts up in the standby mode.
[ON]
Starts the projection immediately.
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1) Press
as
to select [PROJECTION METHOD].
2) Press
qw
to switch the projection method.
f
The items will switch each time you press the button.
[FRONT/DESK]
When installing the projector on the desk, etc., in front of the screen.
[FRONT/CEILING]
When installing the projector in front of the screen with the Ceiling Mount Bracket (optional).
[REAR/DESK]
When installing the projector on the desk, etc., behind the screen (with a translucent screen).
[REAR/CEILING]
When installing the projector behind the screen (with a translucent screen) with the Ceiling Mount
Bracket (optional).
[LAMP POWER]
Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1) Press
as
to select [LAMP POWER].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
ENGLISH
-
79
Chapter 4 Settings - [PROJECTOR SETUP] menu
