Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 143
2) Turn on all the projectors.
3) Press
as
to select [DATA CLONING] on the projector to copy.
4) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
5) Enter a security password and press the <ENTER> button.
f
The
[DATA CLONING]
screen is displayed.
6) Press
as
to select [SELECT PROJECTOR].
7) Press the <ENTER> button.
f
The projectors in the same subnet are displayed as a list.
8) Press
as
to select the copy destination projector.
9) Press the <ENTER> button.
f
To select multiple projectors, repeat Steps
8)
to
9)
.
10) Press the <DEFAULT> button on the remote control.
f
The confirmation screen is displayed.
11) Press
qw
to select [OK], and press the <ENTER> button.
f
Start the copy of data between projectors.
Once the copy is completed, results are displayed as a list in the
[DATA CLONING]
screen.
Meanings of the marks displayed in the list are as follows.
g
Green: Data copy has succeeded.
g
Red: Data copy has failed. Confirm the connection of the LAN cable and power status of the copy
destination projector.
f
The copy destination projector will display the data cloning request message, transfer to standby state
automatically, and perform the copy of the data.
12) Turn on the copy destination projector.
f
The copied content is reflected to the projector.
Note
f
The security password is the password set in the [SECURITY] menu
→
[SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq
f
The light source indicator <LIGHT1>/<LIGHT2> and the temperature indicator <TEMP> of the copy destination projector blink while copying
the data. Confirm the blinking of the indicators stops, and then turn on the power supply.
Setting [WRITE PROTECT]
Set if the copy of data using the data cloning function is permitted or not.
1) Press
as
to select [DATA CLONING] on the copy destination projector.
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The
[DATA CLONING]
screen is displayed.
4) Press
as
to select [WRITE PROTECT].
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Permits operations of the data cloning function from another projector.
[ON]
Does not permit the operations of the data cloning function from another projector.
f
Data copy will not be possible when [ON] is set. When it is not necessary to copy data of another
projector, set to [ON] so that the data is not changed by mistake.