Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 183
[PROJECTOR TYPE]
Displays the type of the projector.
[SERIAL NUMBER]
Displays the serial number of the projector.
[PROJECTOR RUNTIME]
Displays the runtime of the projector.
[LIGHT RUNTIME]
Displays the runtime of the light source 1 and the light source 2.
[CONTINUOUS LIGHTING
TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
[FIRMWARE VERSION]
Displays the firmware version of the projector.
[INTAKE AIR TEMP.]
*1
Displays the intake air temperature status.
[OPTICS MODULE TEMP.]
*1
Displays the internal temperature status.
[EXHAUST AIR TEMP.]
*1
Displays the exhaust air temperature status.
[LIGHT1 TEMP.]
*1
Displays the light source 1 temperature status.
[LIGHT2 TEMP.]
*1
Displays the light source 2 temperature status.
[SELF TEST]
Displays the self-diagnosis information.
[INPUT]
Displays the input terminal currently selected.
Displays the representative input terminal when one image is displayed with multiple input signals.
[SIGNAL NAME]
Displays the input signal name.
[MEMORY NO.]
Displays the memory number of the input signal.
[BACKUP INPUT STATUS]
Displays whether switching to the backup input signal is possible or not when [BACKUP INPUT
MODE] is set to [OFF]. (
x
page 126)
[NUMBER OF REGISTERED
SIGNAL]
Displays the number of registered signals.
[COOLING CONDITION]
Displays the set cooling conditions.
[ATMOSPHERIC PRESSURE]
Displays the atmospheric pressure.
[REMOTE2 STATUS]
Displays the control status of the REMOTE2.
[AC VOLTAGE]
Displays the input supply voltage.
[LENS]
[LENS TYPE]
Displays the projection lens type.
[ON COUNT]
[POWER ON TIMES]
Displays the number of times the power is turned on.
[UPGRADE KIT]
[ET-NUK10]
Displays the activation status by the NFC Upgrade Kit (Model No.:
ET-NUK10).
Or, displays the status of the NFC function.
[ACTIVATED]: The NFC function can be used.
[NOT ACTIVATED]: The NFC function cannot be used.
[SLOT]
Displays the product model number of the Function Board installed in <SLOT>.
Also, the firmware version is displayed after the product model number.
[OPERATING MODE]
Displays the setting value of the [PROJECTOR SETUP] menu
→
[OPERATION SETTING]
→
[OPERATING MODE].
[NORMAL]
Displays the runtime of the light source with [OPERATING MODE] set to [NORMAL].
[ECO]
Displays the runtime of the light source with [OPERATING MODE] set to [ECO].
[QUIET]
Displays the runtime of the light source with [OPERATING MODE] set to [QUIET].
[USER1]
Displays the runtime of the light source with [OPERATING MODE] set to [USER1].
[USER2]
Displays the runtime of the light source with [OPERATING MODE] set to [USER2].
[USER3]
Displays the runtime of the light source with [OPERATING MODE] set to [USER3].
[CONSOLIDATED RUNTIME]
*2
Converts the total runtime of the light sources with [OPERATING MODE] set to each item into the
time used with the [NORMAL] setting.
The consolidated runtime is used for a rough indication about when to perform maintenance when the
projector is used in combination of each item in [OPERATING MODE].
[ANGLE INFORMATION]
[ROLL ANGLE]
*3
Displays the horizontal swing angle based on the detection result of
the built-in angle sensor.
[PITCH ANGLE]
*3
Displays the vertical tilt angle based on the detection result of the
built-in angle sensor.