Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 167
5 Display the status by color.
Green: There is an allowance for brightness correction.
Yellow: There is little allowance for brightness correction.
Red: There is a brightness control error.
6 Display error detailed messages.
7 Display error messages.
When the message [Failed to apply BRIGHTNESS CONTROL to some projectors.] appears, it means that synchronization with the
projector displayed in red has failed.
Press
as
to select the projector displayed in red, and press the <ENTER> button to display the error details.
8 Update to the latest status information.
r
Error details
Error message
Measures to take
[Exceed maximum number of
projectors.]
f
Limit the number of projectors in one group to eight.
f
To synchronize nine or more projectors, use a computer and “Multi Monitoring & Control
Software”
*1
.
[Please check the COMMAND
CONTROL setting.]
f
Set the password of the administrator account.
f
Set [NETWORK CONTROL]
→
[COMMAND CONTROL] to [ON] for the projector in error.
f
Set [NETWORK CONTROL]
→
[COMMAND PORT] of all linked projectors to the same value.
[Please check the USER NAME
and PASSWORD in the COMMAND
CONTROL setting.]
f
Set the administrator account (user name and password) of all linked projectors to the same
setting.
[Cannot apply BRIGHTNESS
CONTROL. Please check projector
status.]
f
The projector is in standby. Switch on the power.
[Brightness Sensor Error]
f
There is a problem with the brightness sensor. If problems persist even after switching on the
power, consult your dealer.
*1 “Multi Monitoring & Control Software” can be downloaded from the following website.
https://panasonic.net/cns/projector/
Note
f
If the synchronized projectors are not displayed in the list, check the following:
g
Are there devices with the same IP address on the network?
g
Are the LAN cables connected correctly? (
x
page 217)
g
Are the subnets of the projectors the same?
g
Are the same [LINK] settings applied to a group?
f
Refer to [PROJECTOR NAME] (
x
page 207) or
“[Network config] page” (
x
page 235) on how to change the projector name.
Setting [STARTUP CALIBRATION]
Set whether to measure the brightness and color of the light source when the power is turned on.
1) Press
as
to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f
The
[BRIGHTNESS CONTROL]
screen is displayed.
3) Press
as
to select [STARTUP CALIBRATION].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Does not measure the brightness and color of the light source when the power is turned on.
[ON]
Measures the brightness and color of the light source by the brightness sensor after the power is
turned on and the light source is illuminated.
Note
f
The [STARTUP CALIBRATION] setting will be reflected at the time when the item is switched using
qw
.
f
The [STARTUP CALIBRATION] setting item is common with the following menu item.
g
The [PROJECTOR SETUP] menu
→
[BRIGHTNESS CONTROL]
→
[BRIGHTNESS CONTROL SETUP]
→
[STARTUP CALIBRATION]
Setting [REGULAR CALIBRATION]
Set whether to measure the brightness and color of the light source at a specified time.
1) Press
as
to select [BRIGHTNESS CONTROL].
