Chapter 5
Operations — Network connection
156 - ENGLISH
f
When laying cables between the twisted-pair-cable transmitter and the projector, confirm that cable characteristics are compatible with
CAT5e or higher using tools such as a cable tester or cable analyzer.
When a relay connector is used, include it in the measurement.
f
Do not use a hub between the twisted-pair-cable transmitter and the projector.
f
Do not pull cables forcefully. Also, do not bend or fold cables unnecessarily.
f
To reduce the effects of noise as much as possible, stretch out the cables between the twisted-pair-cable transmitter and the projector
without any loops.
f
Lay the cables between the twisted-pair-cable transmitter and the projector away from other cables, particularly power cables.
f
When laying multiple cables, run them side by side along the shortest distance possible without bundling them together.
f
After laying the cable, confirm that the value of [SIGNAL QUALITY] in the [NETWORK/USB] menu
→
[DIGITAL LINK STATUS] is displayed
in green, which indicates a normal quality.
f
For twisted-pair-cable transmitters of other manufacturers that the operation has been verified with this projector, visit the Panasonic
website (https://panasonic.net/cns/projector/). Note that the verification for devices of other manufacturers has been made for the items set
by Panasonic Corporation, and not all the operations have been verified. For operation or performance problems caused by the devices of
other manufacturers, contact the respective manufacturers.
Setting the projector
1) Connect the projector to a computer using a LAN cable.
2) Turn on the power of the projector.
3)
From the main menu, select the [NETWORK/USB] menu
→
[WIRED LAN], and press the <ENTER>
button.
4) Perform the [WIRED LAN] setting.
f
For details, refer to [WIRED LAN] (
x
page 141).
Note
f
To connect to an existing network, perform after consulting your network administrator.
r
Factory default setting
f
Following is preset as the factory default setting.
[DHCP]
[OFF]
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1]/[DNS2]
(Blank)
[EAP]
[NONE]
Operating the computer
1) Turn on the power of the computer.
2) Perform the network setting following the instruction of your network administrator.
f
Operation from the computer is possible by configuring the network setting of the computer as follows if the
projector is in the factory default setting.
[IP ADDRESS]
192.168.10.101
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
