Switching the projector on/off
Basic Operation
24 -
E
NGLISH
Switching off the projector
When operating the projector, check the status of the
POWER
indicator. (
¨
page 22)
INPUT SELECT
RELEASE
POWER
indicator
POWER LOCK
indicator
(1), (2)
Press the POWER button.
1 )
7KHFRQ¿UPDWLRQVFUHHQZLOOEHGLVSOD\HG
Without any operation for 10 seconds or press any button other than the
z
POWER
EXWWRQWKHFRQ¿UPDWLRQ
screen will go off and return to the projection.
Press the POWER button again.
2 )
The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and
z
POWER
indicator lights in orange. Wait until the
POWER LOCK
indicator and
POWER
indicator turn into red.
If
z
STANDBY MODE
is set to
NORMAL
, the
POWER
LQGLFDWRUÀDVKHVLQUHG
(
¨
page 42)
You can set to
z
ON
or
2))
the beeping sound that occurs when the
POWER
button is in operation in
AUDIO SETTING
.
(
¨
page 43)
After the POWER LOCK indicator and POWER indicator light in red, disconnect the
3 )
PDLQVSOXJIURPWKHPDLQVVRFNHW
(
¨
page 21)
For urgency, you may disconnect the mains plug immediately since the
z
',5(&732:(52))
function is
installed.
5HPDUNV
&RQ¿UPWKDW
z
CONTROL PANEL
(when operating with the projector body) or
REMOTE CONTROLLER
(when
operating with the remote control) under
CONTROL DEVICE SETUP
in the
SECURITY
menu is set to
ENABLE
.
(
¨
page 46)
You can switch off the power by pressing the
z
POWER
button for 0.5 seconds or more.
