Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls, Operating Instructions Manual

Page: 55 / 140

E
NGLISH
-55
Care
and
m
aintenance
+
Press the ENTER button to
display the “OPTION2” menu,
and then press the
F
or
G
button to select “LAMP
RUNTIME”.
,
Press and hold the ENTER
button for approximately 3
seconds.
The “LAMP RUNTIME” will
change to “TIME RESET
[POWER OFF]”.
-
Turn off the power.
This will reset the cumulative usage
time for the lamp unit to “0”.
Refer to page 26 for details on
how to turn off the power.
'
Install the lamp unit cover, and
then use a Phillips screwdriver
to securely tighten the lamp
unit cover fixing screws.
(
Connect the power cord.
)
Press the POWER button so
that a picture is projected onto
the screen.
*
Press the MENU button to
display the “MAIN MENU”, and
then press the
F
or
G
button
to select “OPTION2”.
M E N U
K E Y S T O N E
P I C T U R E
P O S I T I O N
I N D E X W I N D O W
S H U T T E R
V O L U M E
L A N G U A G E
O P T I O N 1
O P T I O N 2
S E C U R I T Y
N E T W O R K
S E L E C T E N T E R E X I T
O P T I O N 2
B A C K C O L O R B L U E
F R O N T / R E A R F R O N T
D E S K / C E I L I N G D E S K
F A N C O N T R O L S T A N D A R D
L A M P P O W E R H I G H
L A M P R U N T I M E 1 8 2 0 H
F U N C 1 I N D E X
C O N T R O L K E Y O N
A U T O P O W . O F F D I S A B L E
P O W E R M E M O R Y O N
S E L E C T R E T R N
O P T I O N 2
B A C K C O L O R B L U E
F R O N T / R E A R F R O N T
D E S K / C E I L I N G D E S K
F A N C O N T R O L S T A N D A R D
L A M P P O W E R H I G H
T I M E R E S E T [ P O W E R O F F ]
F U N C 1 I N D E X
C O N T R O L K E Y O N
A U T O P O W . O F F D I S A B L E
P O W E R M E M O R Y O N
S E L E C T R E T R N
NOTE:
B
Be sure to install the lamp unit
and the lamp unit cover securely.
If they are not securely installed,
it may cause the protection
circuit to operate so that the
power cannot be turned on.
NOTE:
B
If the MENU button is pressed,
the lamp time resetting screen
will be cancelled.
NOTE:
B
If the power cord was
disconnected during projection
when the projector was used
the last time, projection will start
after the power cord is
connected (when “POWER
MEMORY” in the “OPTION2”
menu is set to “ON”). Refer to
page 46 for details.