Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls, Operating Instructions Manual

Page: 17 / 140

E
NGLISH
-17
Preparation
#
RGB INPUT indicator
This indicator illuminates when a signal is being input to the RGB IN
connector.
$
LAMP indicator (page 51)
This indicator illuminates when it is time to replace the lamp unit. It flashes
if a circuit abnormality is detected.
%
TEMP indicator (page 50)
This indicator illuminates if an abnormally high temperature is detected inside
the projector or around it. If the temperature rises above a certain level, the
power supply will be turned off automatically and the indicator will flash.
&
Power indicator (pages 24, 26 and 27)
This indicator illuminates red when the projector is in standby mode, and it
illuminates green when a picture starts to be projected.
'
POWER button (pages 24 and 26)
(
INPUT buttons (page 25)
These buttons are used to switch the input signals from the connected equipment.
)
AUTO SETUP button (pages 25 and 28)
If this button is pressed while a picture is being projected, the projection
settings will be adjusted automatically in accordance with the signal being
input. In addition, the angle of tilt of the projector will be automatically
detected and adjusted in order to correct any keystone distortion.
*
MENU button (pages 32 and 34)
This button is used to display the “MAIN MENU”. When a menu screen is
being displayed, this button can be used to return to a previous screen or
to clear the screen.
+
Arrow (
F FG GI I
and
H H
) buttons (page 34)
These buttons are used to select and adjust items in the on-screen menus.
,
ENTER button (page 34)
This button is used to accept and to activate items selected in the on-screen menus.
-
FREEZE button (page 29)
This button is used to momentarily freeze projection so that a still picture is displayed.
.
SHUTTER button (page 29)
This button is used to momentarily turn off the picture and sound.
/
/- buttons (page 30)
These buttons are used to adjust the volume of the sound output from the
projector’s built-in speaker. Refer to page 33 for details on how to adjust
the volume using the buttons on the projector control panel.
0
STD (standard) button (page 35)
This button is used to reset the projector adjustment values to the factory
default settings.
1
INDEX WINDOW button (page 31)
This button can be used to split the image projection area into a still picture and a
moving picture. When “NETWORK” is selected, screen display will be switched.
2
D.ZOOM +/- buttons (page 30)
These buttons are used to enlarge the projected image.