7
Getting Start
ed
Requires two AA batteries (supplied).
2
. Install batteries in the battery compartment.
• Battery polarity (+) and (-) must match the markings
inside the compartment.
Two AA size
Remote Control Battery Installation
1
. Slide the battery cover in direction of arrow.
3
. Slide the battery cover until it snaps shut.
Incorrect battery installation can cause the batteries to
leak, leading to personal injury and/or damage to the
Remote Control.
Observe the following precautions:
1. Always replace batteries with a pair of new ones.
2. Do not combine a new battery with an old one.
3. Do not mix battery types (example: “Zinc Carbon”
with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
5. Battery replacement is necessary when the Remote
Control acts sporadically or stops operating the
Projection Display set.
Helpful Hints:
(1) Frequent Remote Control users, choose
long-lasting Alkaline batteries as replacements.
(2) Whenever batteries are removed,
you may need
to reset Remote Control infrared codes.
We suggest making a note of the codes on
page 58 prior to setting up the remote.
Reset All Memory Functions
Use when moving unit to a new location, or when First
Time Setup needs to be done over.
Press together the VOL- button
on the unit and OK button on the
Remote Control for more than
3 seconds. Unit shuts itself off when
reset is done.
• POWER indicator flashes red. After
flashing stops, unplug the unit then
plug it back in and turn power ON.
CAUTION
Note:
• When using “Control with HDMI (HDAVI Control)”, with the
device connected, set “Ctrl with HDMI” first to “Off” and then
“On” using the Setup Menu. (p. 56)
