Panasonic PT-51HX42CF, Service Manual

Page: 61 / 144

- 21 -
Service Manual
6. Wire the anode lead wire.
Figure 21. Wire guide.
7. Install yoke with other CRT neck assemblies on
CRT neck in the same order and position as
removed from the defective CRT.
8. Press yoke against bell of CRT and tighten the
clamp just snug enough so it will not easily shift.
9. Assemble CRT focus lens assembly to new CRT
with (4) screws. Make sure focus lens adjustment
nut is in the same location as on other CRT focus
lens.
Figure 22. CRT screw tightening order.
Note: Please assemble with screws in the order
shown and tighten with the same torque.
Optical block position adjustment
Figure 23. Optical block position.
The optical block mounting has holes to allow for the
different size projection screens. These mounts will
adjust to projection screens. If the optical block is removed for service or is
replaced, it is important that the correct mounting holes
are used.
Optical bracket (front)
RED CRT GREEN CRT BLUE CRT
1
2 3
4
51/61
51/61
51/61
51/61
51/61
51/61
46
46
46
46
46
46