3.1 Using 10GBASE-T
3.2 Installing on level shelves
10GBASE-T was established as per the IEEE 802.3an-2006 standard, and depending
upon the twisted pair cables, it is an Ethernet standard whereas communications are
transmissible at 10 Gbps, up to maximum of a 100 m.
In order to attenuate the noise effects in regard to alien crosstalk noise, and
exogenous noise, it is recommended that STP cables be used.
Communications might be affected due to exogenous noise to the cables.
The person responsible for laying the cables might request to select appropriate
cables, and to make improvements regarding environmental noise.
(1) Supported cable types
(2) Cable laying environment
(1) Apply the supplied rubber feet onto the bottom surface of the unit.
(2) Install in a level area.
Caution
- Do not stack and use.
Set up with a clearance of
20 mm or more.
Installation and Configuration
3
12
3.3 Mounting to rack
Take out the supplied 2 mounting brackets
(for 19-inch rack) and 8 screws (for fixing the
main unit and the mounting bracket), and fix
the brackets to the main unit by tightening
screws into 4 holes located at the sides. Then,
mount this Ethernet Switch firmly to the rack
using the supplied 4 screws (for 19-inch rack)
or screws furnished at the rack.
Bottom surface
Rubber feet
Cat. 5e or below
Cat. 6
Cat. 6A
Cannot be used
Maximum 37 m (* From 37 m to 55 m there is alien crosstalk)
Maximum 100 m
Transmission distance
Cable type
