SD CARD SLOT
POWER1
STATUS
SD CARD
ZEQUO 5410DL
POWER2
STACK ID
1
2
3
4
CONSOLE
9600.N.8.1(DTE)
1
2
3
4
13
14
15
16
9
10
11
12
5
6
7
8
5
6
7
8
9
10
11
12
13
14
15
16
POWER1 LED and POWER2 LED
Green Light
: Power is ON.
Off
: Power is OFF. Or, an internal power fault.
STATUS LED
Green Light
: The system is normally operating.
Green Blink
: There’re one or some ports which are within 3 days after a loop resolution
Orange Light
: Starting up
Orange Blink
: Malfunction (Contact the seller.)
Off
: Power is OFF.
SD CARD LED
Green Light
: SD card inserted
Green Blink
: Reading/writing data
Orange Light
: SD card error
Off
: No SD card
STACK ID LED
Indicating “H” and the STACK ID alternately : Master switch
Indicating “h” and the STACK ID alternately : Backup master switch
Off
: Stack functions invalid
Port LED
Port LED
(SFP+ port 5-16)
Port 1-4
Green Light
: Link is established at 100/1000 Mbps or 10 Gbps.
Green Blink
: Transmitting and receiving data at 100/1000 Mbps or 10 Gbps.
: Shutting off due to loop detection and shutoff functions/storm controls/
BPDU guard
: Transmitting and receiving just the administration packets
: Shutting off due to loop detection and shutoff functions/storm controls/
BPDU guard
: Transmitting and receiving just the administration packets
Orange Light
Orange Blink
Off
: No devices is connected.
Green Light
: Link is established at 1000 Mbps or 10 Gbps.
Green Blink
: Transmitting and receiving data at 1000 Mbps or 10 Gbps.
Orange Light
Orange Blink
Off
: No devices is connected.
POWER1 LED
POWER2 LED
D
E
L
S
U
T
A
T
S
D
E
L
D
R
A
C
D
S
Port LED
STACK ID LED
11
*The following information is also displayed depending upon the device’s state.
“P” : Power failure
“F” : Fan failure
“L” : Within 3 days after a loop resolution
Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage this
Ethernet Switch.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
Use our optional RJ45-DSub 9-pin console cable (PN72001) for the console cable.
