Part Names and Functions
10
2
MAC Address label
Power port
Serial number label
Ground terminal
screw
Magnified view on the next page
Power cord hook block
10/100/1000BASE-T port
Back panel
Front panel
Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
10/100/1000BASE-T port (ports 1-24) supporting PoE power supply
The port can supply PoE power conforming with IEEE802.3af. Connect a Powered
Device conforming with IEEE802.3af. Devices such as 10/100/1000BASE-T terminal,
hub, repeater, bridge, and Switching Hub can be connected to this port. Install the
device so that the length of twisted pair cable (Cat5e or above) becomes 100 m or
less.
Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage
this Switching Hub.
Use the RJ45-D-Sub 9-pin console cable to connect a console.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
Console port
