- 4 -
STANDARD INSTALLATION PROCEDURE, MV6W
CONTENTS INCLUDE:
(1) Wall mount Bracket
(1) Dome base
(1) Dome
(1) Dome liner
(1) Camera swivel plate
(1) Camera mount with camera, lens, and PC Board
(1) Camera adjustment arm
(1) Camera adjustment template
(2) 4-40 x 1/4" screws
(1) 8-32 x 3/8" screw
INSTALLATION
1
. Locate the area on the wall where the bracket is to be
mounted. Cut a hole no larger than 1" in diameter and
feed the necessary wires/cable through (Figure 1).
2
. Feed wires/cable through the hole in the back side of the
bracket and out through end of the pipe.
3
. Attach the bracket to the wall with fasteners that best fit
the application.
HOUSING INSTALLATION
1
. Once the bracket is secure, feed all wires/cable through
the top dome. Slide the top dome onto the bottom of
the bracket; the grommet should be secure around the
bracket pipe (Figure 2).
4
. Once the housing has been secured to the bracket, slide
the top dome back down along the bracket until it fits on
top of the housing. The grommet will keep the top dome in
place.
TOP DOME
GROMMET
3/4" CONDUIT CONNECTOR
Figure 1
Figure 2
Figure 3
2
. Once the top dome has been placed on the bracket, feed all
wires/cable through the 3/4" conduit connector and camera
housing.
3
. Slide the housing onto the bracket, then tighten down the screw
on the 3/4" conduit connector (Figure 3).
Note:
The connector will need to be tightened completly
down to secure the housing to bracket.
Make necessary camera adjustments and complete the
installation process as specified elsewhere in these instructions.
10.8"
7.0"
5.4"
3.4"
3.3"
PCF6W, PCV6W Dimensions
