54
AHU Kit – Installation Instructions – 07/2023
Electrical Wiring
5
Stranded wire
1.
Cut the wire end with cutting pliers, then strip the insulation to expose the stranded wiring about
10 mm and tightly twist the wire ends.
Strip 10 mm
Wire-end
sleeve
2.
Using a flat-blade screwdriver, loosen the terminal screw(s) on the terminal plate.
3. Attach a wire-end sleeve to each stripped wire end using a crimping tool.
4. Place the wire-end sleeve into the socket on the connector and replace and tighten the removed
terminal screw using a flat-blade screwdriver.
Special washer
Screw and special washer
Screw
Terminal plate
Wire
Wire-end sleeve
Wire
Wire-end sleeve
Shielded wire
1. Remove cable sheath. Take care not to scratch braided shield.
2. Unbraid the braided shield mesh carefully and twist the unbraided shield mesh tightly together.
Insulate the shield mesh by covering them with an insulation tube or wrapping insulation tape
around wire.
Insulation tape
Shield mesh
3. Remove insulation of signal wire.
Insulation tape
Shield mesh
8 mm
4. Attach wire-end sleeves to the signal wires and the shield mesh insulated in step 2 using a
crimping tool.
Wire-end sleeve
5. Connect the shield for the inter-unit control wiring to ground.
Summary of Contents for PAW-160MAH3M
Page 2: ...Notes...
Page 90: ...90 AHU Kit Installation Instructions 07 2023 Parameter settings 9 Notes...
Page 91: ...Notes...