Colour Enhancentent Light
(optional)
Danger:
LIGHT
RELEASE
REFLECTOR
CASING
•
When
the bulb, use only lamp bulbs
supplied by
to reduce the risk of fire.
Use a cloth or tissue when
the bulb,
as skin oils will decrease the bulb
To
prevent
burn hazard, disconnect the
Colour
Light Unit and allow the
lamp to cool before replacing.
•
Do not connect any light other than the
standard light included. Use of a different light,
modification to the light connector or light jack
may cause severe battery drain and fire
hazard.
1 6
Using the
5W
Light
Use to brighten the natural colours in a
scene.
1
Slide Light into built-in Light Mount.
Be sure the Light locks into place.
2
LIGHT
Press Light button ON.
RELEASE
00
To remove the Light:
Press the LIGHT RELEASE button
and slide the Light off.
CAUTION:
This light becomes hot during operation.
Replacing the Bulb
1
Turn screw counterclockwise
on the underside of the reflector casing
and remove.
2
Turn reflector casing counter
clockwise
only as far as shown in the
diagram and pull it off the bulb housing.
3
Pull the old bulb off the base.
Using a clean cloth or tissue, replace it.
4
Replace the reflector casing
on the bulb housing, turning it clockwise.
Replace the screw.
Note:
•
If
the Enhancement Light for an
period of time, take note of the
surrounding temperature and be sure to
pro':'ide ventilation when using in a hot
environment.
•
Using the Enhancement Light when the
Palmcorder is powered by a car battery
may shorten bulb life.
•
Do not attempt to lift or
the
Palmcorder by holding the
Light.
