Panasonic OmniVision PV-M1347, Service Manual

Page: 20 / 143

2-2
TV
CRT C.B.A.
Anode Cap
P354
Deflection
Yoke
Connector
Main
C.B.A.
TV Main C.B.A.
Clampers
Degaussing
Coil Connector
P4591
(Model : A, B,
C, D, E, F, G, H)
P4605
(Model : I)
Stereo Amp
C.B.A.
(Model : I)
P4604
(Model : I)
Clamper
CRT Unit
3 VCR Unit
VCR Unit
Disassembly Procedure
1. Discharge the Anode to the CRT Ground. Then, remove the
Anode Cap.
2. Disconnect the Connector P354 from the CRT C.B.A.
3. Carefully pull out the CRT C.B.A. from the CRT Unit.
4. Disconnect the Deflection Yoke Connector and the
Degaussing Coil Connector from the Main C.B.A.
5. (Model : A, B, C, D, E, F, G, H )
Disconnect the Connector P4591 on the Main C.B.A. and
remove the leads from the clampers.
(Model : I )
Disconnect 2 Connectors P4604 and P4605 on the Stereo
Amp C.B.A. and remove the leads from the clampers.
Fig. D4-1
6. (Model: A, B, C, D, E)
Slightly lift up the rear side of the VCR Unit to release Tabs
(B).
(Model: F, G, H, I)
Slightly lift up the rear side of the VCR Unit to release Tabs
(B) and (C).
7. Slide the VCR Unit out as far as it will go.
Then, lift up the VCR Unit to release 3 Guide Tabs (A) and
remove the VCR Unit all the way out from the TV cavity.
Rear View
Screws (A)
Screws (A)
2 Rear Cover
(Model: F, G, H, I)
Rear View
(Model: A, B, C, D, E)
Screws (A)
Screws (A)
2 Rear Cover
Rear Cover
Disassembly Procedure
Remove 7 Screws (A). Then, pull the Rear Cover away.
Fig. D3-1
Fig. D3-2