Panasonic Omnivision PV-C1321, Service Manual

Page: 230 / 247

32
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Tape Operation (continued)
Repeat Play
Set to see a recording over and over.
1
2
1) Press to
select “REPEAT
PLAY.”
2) Press to set
REPEAT PLAY
“ON” or “OFF.”
3
M A I N MENU
T V VCR
EX I T CLOCK C H
LANGUAGE
SET : ACT I ON
SELECT :
1) Press
to select “VCR.”
2) Press ACTION
to display SET
UP VCR screen.
Press ACTION*
to display MAIN MENU.
4
Press ACTION twice
to end setup.
REPEAT PLAY PLAY : OFF FF
T I MER PROGRAMMING
T I ME STAMP : ON
REMOTE WARN I NG : ON
SELECT :
SET :
END : ACT I ON
SET UP VCR
Zero Search
To quickly return to a specific tape counter location.
1
2
Press STOP.
4
5
3
Continue playback, rewind, or
fast forward.
Press COUNTER
RESET at the
desired position to
reset to “0:00:00.”
• : Present position mark
: Zero position mark
• Unit goes into FF or REW mode and
stops at the last point the Counter was
set to 0:00:00.
Press DISPLAY during playback
to display the Counter.
Press CM/ZERO repeatedly to
select skip time in Play mode.
Commercial Skip
By pressing the CM/ZERO button in Playback
mode you can skip over 1 to 3 minutes of
recorded tape in just a few seconds.
1
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
BEG I N END
1 : 23 : 45
BEG I N END
0 : 00 : 00
• If a blank portion exists on the tape, and
depending on the position of the mark,
the mark display may be out of position.
Zero Search Note
• Playback repeats when tape end is reached
or unrecorded portion over 30 seconds is
detected.
• During playback, you may also press
PLAY/REPEAT repeatedly on the unit to
select REPEAT “ON” or “OFF.”
Repeat Play Notes
• No indication appears.
C2061- P30-33 Tape OP 00.12.14, 5:33 PM 32