8
The VCR supplies a signal to the TV via the RF coaxial cable
on channel AU28–69 or NZ21– 69.
It is possible to view the video picture on your TV in the same
way that you watch TV broadcasts.
If you have connected the VCR to the TV through the Audio/
Video input sockets, then you do not need to follow the
procedure below.
Preparation
≥
Turn on the TV and the VCR.
Operation
1
Hold down the MENU button
V
V
V
V
V
for 5 seconds or
more.
2
Set the TV to an unused position which you wish to
use for your video playback.
≥
Tune the TV until the display
shown on the right appears on
the screen. (Please refer to the
TV manufacturers operating
instructions regarding tuning.)
3
Press the MENU button
V
.
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1
Hold down the MENU button
V
for 5 seconds or more.
≥
The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
2
Enter the desired channel number (AU28–69, NZ21– 69)
by the Numeric buttons
2
or the Channel button
P
.
≥
Ensure that the VCR/TV switch
R
is set to “VCR”.
≥
Set the RF output channel of the VCR to “
ss
” (RF OFF)
when the VCR is connected to the TV via the Audio/
Video cable.
Press the Channel button
P
to display “
ss
”.
≥
It is also possible to select by pressing the Numeric
buttons
2
(only for Australia).
Example:
3
Press the MENU button
V
to finish the setting mode.
4
Retune your TV to the new RF channel for the VCR.
(Refer to the operations on the left.)
Tuning the TV to Your VCR
Panasonic VCR
END:MENU
RF SELECT BG I
≥
DK
RF SELECT:
On Screen Display
(RF OFF)
2
8
28:
Panasonic VCR
END:MENU
RF SELECT BG I
≥
DK
RF SELECT:
28 37
…
…
69
21E
…
69E
(Initial position)
For Australia
For New Zealand
VCR display
