Before using
14
VQT0T93
7
Press the joystick to determine the setting.
ª
To exit the menu screen
Press the [MENU] button.
ª
To get back to the previous screen
Move the joystick left.
ª
About the menu setting
≥
The menu screen does not appear during
recording. And you cannot record when the
menu screen appears.
ª
Operating with remote control
The menu screen transition is the same as when
the buttons on the main unit are used.
1
Press the [MENU] button.
2
Select a menu item.
≥
Use the direction buttons
(
3
,
2
,
1
,
4
) and
[ENTER] button in place of the joystick on the
main unit.
3
Press the [MENU] button to exit the menu
screen.
Setting date and time
If the screen shows the incorrect date/time, then
adjust it.
≥
Set to Tape Recording Mode or Card
Recording Mode.
1
Set [BASIC] >> [CLOCK SET] >> [YES].
2
Move the joystick left or right in order to
select the item to be set. Then move the
joystick up or down to set the desired value.
≥
The year will change as follows:
2000, 2001, ..., 2089, 2000, ...
≥
The 24-hour clock is used.
3
Press the joystick to determine the setting.
≥
The clock function starts at [00] seconds.
ª
About date/time
≥
The date and time function are driven by a
built-in lithium battery.
≥
Make sure to check the time before recording
because the built-in clock is not very accurate.
ª
Recharging the built-in lithium battery
≥
If [
0
] or [--] is indicated when the camera is
turned on, then the built-in lithium battery runs
down. Connect the AC adaptor to the camera or
place the battery on the camera, and the built-in
lithium battery will be recharged. Leave the
camera as is for approx. 24 hours, and the
battery will drive the date and time for approx.
6 months. (Even if the [OFF/ON] switch is set to
[OFF], the battery is still being recharged.)
WARNING
THE LITHIUM BATTERY IN THIS UNIT MUST
ONLY BE REPLACED BY QUALIFIED
PERSONNEL. IF THIS IS NECESSARY,
CONTACT THE PANASONIC CUSTOMER
CARE CENTRE ON 132600 FOR YOUR
NEAREST AUTHORIZED SERVICE CENTRE.
2006
VQT0T93ENG.book 14 ページ ２００５年１１月２８日 月曜日 午後９時６分
