12
Connecting the VCR to a Decoder/Connecting the VCR to a Stereo Amplifier
To connect this VCR to a decoder or a stereo amplifier, make the connections shown in the illustration below.
For the connection to the TV, see pages 6–7.
For details about the connection, also read the operating instructions of the decoder or stereo amplifier.
Be sure to keep the VCR, TV and decoder or stereo amplifier switched off until you have finished all connections.
For your safety, do not connect or handle the equipment with wet hands.
To Connect the VCR to a Decoder
Decoder here refers to the device used to decode scrambled broadcasts (Cable TV).
1
Connect a 21-pin Scart lead (not supplied) to the
AV2 21-pin Scart socket
(51)
on the VCR and to
the 21-pin Scart socket on the decoder.
2
Connect the decoder’s mains lead to an AC
mains socket.
3
Set [AV2] to [DECODER]. For details, see
page 39.
Hint:
• [RGB] means separate Red/Green/Blue colour signals. If you connect a
TV equipped with RGB input capability to the AV1 socket
(52)
on this
VCR, and a decoder equipped with RGB output capability to the AV2
socket
(51)
, RGB signal will pass through the VCR to the TV.
To Connect the VCR to a Stereo Amplifier
1
Connect an Audio cable (not supplied) to the
Audio Output sockets
(54)
on the VCR and to
Audio Input sockets on the stereo amplifier.
2
Connect the stereo amplifier’s mains lead to an
AC mains socket.
AV2(DECODER/DECODEUR/EXT)
2
1
21-pin Scart cable
(not supplied)
21-pin Scart socket
To an AC mains socket
Decoder (not supplied)
(51)
Example of NV-FJ780B
AUDIO
OUT/SORTIE
L /G
R /D
2
1
Audio cable (not supplied)
Audio Input sockets
Stereo amplifier (not supplied)
To an AC mains socket
(54)
Example of NV-FJ780B
