92
ª
To Change the Display Mode
By changing [DISPLAY] on the [DISPLAY SETUP]
Sub-Menu, you can change the Display Mode to All Function
Display [ALL], Partial Display [PARTIAL], and Minimum
Display [OFF].
~~~~~~~~~~~~~~~~~~~
Warning/Alarm Indications
If any one of the following indications lights up or flashes,
please check the condition of the Movie Camera.
3
:
Condensation has occurred.
(
l
97)
Y
:
The accidental erasure prevention
slider on the inserted Cassette is
open (that is, set to [SAVE]).
You are about to do audio dubbing
on the unrecorded (blank) portion of
the tape.
No Cassette is inserted.
(
l
61)
6
:
The Battery is low. Recharge it.
(
l
60)
0
:
The built-in battery is low.
(
l
67)
:
:
The video heads are dirty.
(
l
97)
2
END:
The tape came to end during
recording.
REMOTE:
Wrong Remote Controller Mode has
been selected.
(
l
59)
PRINTER ERROR:
The Video Printer is not connected
correctly, or the Video Printer is not
functioning properly.
UNPLAYABLE TAPE
(OTHER FORMAT):
You are attempting to play back a
tape section that has been recorded
with a different TV system.
UNABLE TO A. DUB
(LP RECORDED):
Because the original recording was
done in LP Mode, audio dubbing
cannot be performed.
INCOMPATIBLE
TAPE:
This Cassette is incompatible.
PLEASE RE-OPERATE
AFTER PUSHING
RESET BUTTON:
Mechanism Irregular is detected.
Press the [RESET] Button
(
l
57)
.
This may solve the problem.
TO SERVICE:
It is a malfunction.
CARD FULL:
Card does not have sufficient
memory remaining.
NO CARD:
Card is not inserted.
NO PICTURE:
Card has no pictures recorded on it.
CARD ERROR:
This Card is not compatible with this
Movie Camera.
COPY INHIBITED:
Because the medium is protected by
a copy guard, images cannot be
recorded correctly.
~~~~~~~~~~~~~~~~~~~
Notes and Hints
ª
Concerning the Power Supply
≥
When the Movie Camera is used for a long time, the
Camera body becomes warm, but this is not a malfunction.
≥
If the [CHARGE] Lamp does not light up although the
Battery is attached to AC Adaptor, detach the Battery and
reattach it.
≥
Battery CGP-D110 and CGP-D105 cannot be charged with
this AC Adaptor.
ª
Inserting/Removing the Cassette
≥
In the case of using a previously recorded Cassette, you
can use the Camera Search Function to find the position
where you want to continue recording.
≥
If a new Cassette is inserted, rewind to the beginning of the
tape before starting recording.
≥
When inserting the cassette, make sure it faces in the right
direction and then push it in until it stops.
≥
When opening or closing the Cassette Compartment, push
down the buckle of the Grip Belt so that it does not
obstruct the opening and closing of the Cassette
Compartment.
ª
Alarm Sounds
When [BEEP SOUND] on the [OTHER FUNCTIONS]
Sub-Menu on the [CAMERA FUNCTIONS] Main-Menu is set
to [ON], confirmation/alarm beeps are issued as follows.
1 Beep
≥
When you start recording
≥
When you switch the [OFF/ON/MODE] Switch from [OFF]
to [ON]
2 Beeps
≥
When you pause recording
10 Beeps
≥
If you perform a wrong operation before or during recording
ª
Recording
≥
Before turning on the power, remove the Lens Cap. If the
Lens Cap is still attached when the power is turned [ON],
Automatic White Balance Adjustment
(
l
101)
may not
function correctly.
ª
Recording Check
≥
For Recording Check, the recording speed mode (SP/LP)
must be the same as the mode used for the recording. If
different, playback images will be distorted.
ª
Camera Search
≥
In Camera Search Mode, images may contain
mosaic-pattern noise. This is a phenomenon that is
characteristic of digital video and not a malfunction.
≥
If the recording speed modes (SP/LP) of previous
recording and new recording are different, playback
images may be distorted.
ª
Photoshot
≥
Photoshot Recording results in slightly inferior image
quality.
ª
Progressive Photoshot Function
≥
The still pictures are recorded at a slightly rewound point
from where you press the [PHOTO SHOT] Button.
≥
When you change to the Still Picture Mode, you will hear a
click. This is the sound of the iris closing and not an
indication of malfunction.
≥
If you record still pictures in Progressive Photoshot Mode
when your Movie Camera is set to Programme AE
(
l
72)
,
the brightness of the images may change.
CE.book 92 ページ ２００１年８月６日 月曜日 午後４時２２分
Summary of Contents for NV-DS88EN
Page 53: ...103 ...
