77
Questions and Answers
Technical Specifications
Building-in
Your Oven
Rated Voltage:
230-240 V 50 Hz
Operating Frequency:
2,450 MHz
Input Power:
Max 2770 W
Microwave 1260 W
Grill 1360 W
Convection 1470 W
Output Power:
1000 W (IEC-60705)
Grill 1300 W
Convection 1400 W
Outer Dimensions:
510 mm (W) x 477 mm (D) x 304 mm (H)
Oven Cavity Dimensions:
359 mm (W) x 352 mm (D) x 217 mm (H)
Weight:
with internal accessories 15 kg
Weight and Dimensions are approximate.
Q
My microwave oven causes
interference with my TV, is this
normal?
A
Some radio and TV interference
might occur when you cook with the
microwave oven. This interference
is similar to the interference caused
by small appliances such as mixers,
vacuums, hair dryers, etc. It does
not indicate a problem with your
oven.
Q
Sometimes warm air comes from
the oven vents. Why?
A
The heat given off from the cooking
food warms the air in the oven
cavity. This warmed air is carried
out of the oven by the air flow
pattern in the oven. There isn’t an
airtight seal to the air therefore
steam can escape. There are no
microwaves in the air, or steam.
The oven vents should never be
blocked during cooking.
Q
My oven has an odour and
generates smoke when using the
CONVECTION, COMBINATION
and GRILL function. Why?
A
It is essential that your oven is
wiped out regularly particularly after
cooking by COMBINATION or
GRILL. Any fat and grease that
builds up will begin to smoke if not
cleaned.
Model NN-A774 (stainless steel) can not
be built in, no Trim-Kit is available.
1.
In case of fitting into an oven
housing, please use Panasonic’s
Trim Kit.
NN-TKA70W - White
NN-TKA70M - Silver
NN-TKA70A - Aluminum
2.
Microwave ovens should
not be
built
into a unit
directly above
a
top front venting conventional
cooker. This will invalidate your one
year guarantee.
3.
A microwave which is built in must
be more than 850 mm above floor
level. Read Trim-Kit instructions
carefully before installation.
It is recommended that the
microwave oven is placed below a
conventional oven to avoid heat
damage to the facia of the
microwave.
However if it is necessary to install
the microwave above, then a gap of
at least 15 cm (6 inches) is required
from the top of the conventional
oven casing to the bottom of the
trim kit.
This product is an equipment that fulfills the European standard for EMC disturbances (EMC = Electromagnetic Compatibility)
EN 55011. According to this standard this product is an equipment of group 2, class B and is within required limits. Group 2
means that radio-frequency energy is intentionally generated in the form of electromagnetic radiation for warming up of foods.
Class B means that this product may be used in normal household areas.