2.1. Adjustment of primary latch switch, secondary latch switch and short
switch.
1. Mount the Primary latch switch, the Secondary latch switch and the
short switch to the door hook assembly as shown in ILL.
NOTE:
No specific individual adjustments during installation of the Primary
latch switch, Secondary latch switch or Short switch to the door hook
are required.
2. When mounting the door hook assembly to the oven assembly, adjust
the door hook assembly by moving it in the direction of the arrows in
the illustration so that the oven door will not have any play in it. Check
for play in the door by pulling the door assembly. Make sure that the
latch keys move smoothly after adjustment is completed. Completely
tighten the screws holding the door hook assembly to the oven
assembly.
3. Reconnect the short switch and check the continuity of the monitor
circuit and all latch switches again by following the component test
procedures.
8
Summary of Contents for NN-SN776S
