Panasonic NN-F623MF, Service Manual

Page: 24 / 52

2. Program oven at High power for 1 minute and press start.
A. After approximately 3 seconds, oven stops.
B. During oven operation, input current is approximately 0.4A.
INPUT AMPERE FAILURE CODE
Unplug CN701 <0.4A Oven stops in 3
seconds after
started.
If both a and b check OK, the Inverter Power Supply (U) can be determined to be OK.
7. MEASUREMENTS AND ADJUSTMENTS
7.1. Adjustment of primary latch switch, secondary latch switch and
short switch.
1. Mount the Primary latch switch, the Secondary latch switch and
the short switch to the door hook assembly as shown in ILL.
NOTE:
No specific individual adjustment during installation of the Primary
latch switch, Secondary latch switch or short switch to the door
hook are required.
2. When mounting the door hook assembly to the oven assembly,
adjust the door hook assembly by moving it in the direction of the
arrows in the illustration, so that the oven door will not have any
play in it. Check for play in the door by pulling the door assembly.
Make sure that the latch keys move smoothly after adjustment is
completed. Completely tighten the screws holding the door hook
assembly to the oven assembly.
3. Reconnect the short switch and check the continuity of the
monitor circuit and all latch switches again by following the
component test procedures on .
24