English
08
English
09
Before use
How to use as an iron
The temperature selector of the iron has words, dots and
steam symbols.
The dots are symbols for 3 temperature ranges:
1. Move the steam/dry selector to the dry position to
avoid water leakage.
•
Low temperature
• •
Medium temperature
• • •
High temperature
Some fabrics are labeled with these dots as a guide for
selecting the proper ironing temperature setting.
Use a press cloth if necessary.
Notes:
・
The thermostat operating indicator light goes on and off
alternately to indicate the changing temperature of soleplate.
If you turn the temperature selector from a high temperature
to a lower temperature, wait until the indicator light goes on
before using the iron.
・
Do not place the hot iron on cloth for extended time or wrap
cloth over the hot iron.
Note:
Do not overfill the water tank. The steam will release through
the vents when the iron is positioned vertically.
3. Position the iron in the heel
rest position and make sure
the temperature selector is
set to " 0 ".
4. Plug the power plug into an outlet.
5. Set the temperature selector.
The thermostat operating indicator light goes on.
①
Open the water fill cover.
Hold the iron as shown
and fill the iron with water
up to " MAX " (about 300 mL).
Use a claen cup for filling.
②
Place iron in vertical position to check water level.
③
Close water tank cover firmly to prevent spillage
during ironing.
2. Fill water in the water tank when using steam, power
shot, vertical steam or spray.
Note:
If the temperature of soleplate is high, the light does not go on.
6. Wait until the thermostat operating indicator light goes
off. Hold the iron horizontally and move the steam/dry
selector into the steam position when using the
" power shot ".
（
P10)
•
Please make sure the temperature select indicator
setting is on "
MAX
" when using " high steam " and
" power shot ".
“ MAX ”
7. After each use
①
Set the steam/dry selector to the
dry position. If the steam/dry selector
is not in the dry position after using,
remaining water will move into the
soleplate and can result in burns when
the iron is used next time.
②
Empty the water tank immediately
after using. Do not store the iron
with water in it. If you empty the
water tank after it has cooled,
heat the iron for about 5 minutes
with the temperature selector set
to "
MAX
".
•
Do not wind the power cord around the iron.
It may be damaged by the hot soleplate.
③
Wait until the iron has cooled before
storing it, and always set it on the
heel rest to protect the soleplate
from scratches, corrosion or stains.
Refer to "Guide for Steam/Dry selector" on P10
