Panasonic NC-SSA400, Operating Instructions Manual, Page: 16 / 68

EN15
Troubleshooting
If... Possible cause How to fix
See
page
The unit does not turn on
electricity.
z
You poured in water directly
from a tap and splash water on
the unit.
z It is broken if the electric
components are taken in
water. Please contact an
authorized service center
(as described in the
warranty) for a repair.
—
z
You put the unit on the sink and
caused its bottom wet.
z
You turned the unit upside down
with its bottom wet.
z
You washed the unit in water.
The temperature indication
goes up and down greatly.
z
Immediately after plug in or out, may vary greatly.
—
The temperature indication
is still on when it is
unplugged.
z
When there is remaining battery, it will be indicated. —
z
If it cannot be recovered or feel something strange, disconnect the power plug, reconnect after
30 seconds and operate it again.
z
Inside lid may turn yellow, but no harm for operation.
z “Clickety-clack” sound caused when open and close the lid is the sound caused by the valve
swing to prevent the hot water run off when the unit fall over in accident.
z
Outside body becomes approximately 45 ºC while keep-warm when the room temperature is
high.
The indicator lights flash
alternately and displayed
, .
z This is malfunction of the sensor. Please contact an authorized service
center (as described in the warranty) for a repair.
Before calling a service supplier,
please check the following possible causes.