7.6 The MOTOR replacement
1. Lay down the washing machine on it right side.
2. Remove both lead wire connectors from the MOTOR and the ROTARY SENSOR.
3. Loosen four bolts (M13) mounting the motor by using HW-18, and remove V-belt.
4. Remove four bolt mounting the MOTOR, and remove the motor.
Note: After replace the motor, adjust tension of the V-belt properly.
And then, set micro-processor to initial mode of V-belt tension by operating
Test-No water / Check procedure-E.
7.7 MOTORIZED DRAIN VALVE replacement
1. Lay down the washing machine on it left side.
2. Remove connector from the MOTORIZED
DRAIN VALVE.
3. Remove three screws mounting the
MOTORIZED DRAIN VALVE.
4. Remove slider portion of the MOTORIZED
DRAIN VALVE from the COCK ROD A.
7.8 PUMP replacement
1. Lay down the washing machine on it left side.
2. Loosen clamp and remove two hoses from the PUMP CASING.
3. Remove three screws mounting the PUMP BRACKET.
Connector of
Connector of rotary
Motor
V-belt
Checking tension
of the V-belt
Motorized drain valve
Hose
Hose clamp
Pump casing
Cock rod A
Hose
-14-
Summary of Contents for NA-FS14G2
Page 16: ...8 Wiring Diagram 15 ...
