Installation Instructions - 39
Checking After Installation
Test run after installation
Check for water leakage, abnormal noise,
and proper drainage.
Perform the following procedures
WITHOUT laundry in the drum.
Turn on the tap.
1.
Close the door.
2.
Please spin after moved this washing
3.
machine.
Press the On button. You have to
select “Quick 50” course and “Spin”
mode. Then press the “Start ” button.
After the water is drained, start a test
run.
While holding down the Speed/Eco
4.
and Easy Ironing buttons, press the
On button.
When the display appears as below
5.
(3 seconds), press the Speed/Eco
button.
The remaining time is displayed as below.
The test is run for about 3 minutes.
Check the following:
Is there any abnormal noise?
-
If so, make sure that the appliance is
level.
Is there any water leakage?
-
If so, make sure that the hoses are
properly connected.
You may get the following errors:
Are the hoses properly connected?
-
Is the drain clogged?
Have you properly connected the water-
-
supply hose and turned on the tap?
After recovering from an error, reopen and
reclose the door to resume the test.
NA-140VS4_English.indb 39
2012-12-27 13:12:19
