3. Remove the three (3) screws that secure the handle release
assembly to the nozzle housing.
4. Remove the handle release assembly by sliding it out from
the nozzle housing.
5. Once
handle
release
assembly
is
out
it
can
be
disassembled for parts replacement as shown in the
Exploded View diagram.
3.7.2. Installation
1. Slide the handle release assembly back into the slot in the
nozzle housing.
2. Replace the three screws that hold the frame and pedal
shaft onto the nozzle housing.
3. Replace the nozzle housing.
4. Install and secure the switch cover and dust cover.
5. Install the belt, agitator assembly, and the lower plate
according to the respective instructions.
NOTE: For general servicing, it is necessary to eliminate
pinching of any wire during reassembly. After servicing
any electrical component or electrical enclosure, the unit
should
be
reassembled
and
checked
for
dielectric
breakdown or current leakage.
3.8. Carpet/Bare Floor Assembly
3.8.1. Removal
1. Turn the vacuum over and remove the lower plate, belt and
agitator as outlined in their respective removal sections.
2. Push down on the carpet/bare floor pedal assembly to
remove it from the nozzle housing.
3. Once the carpet/bare floor pedal assembly is out it can be
disassembled for parts replacement as shown in the
Exploded View diagram.
3.8.2. Installation
1. Slide the carpet/bare floor assembly back into the pins in
the nozzle housing.
2. Install the belt, agitator assembly, and the lower plate
according to the respective instructions.
3.9. Motor Replacement
3.9.1. Removal
1. Remove the switch cover and dust cover to expose the
electrical connections and the motor assembly.
2. Remove the lower plate, agitator assembly, belt, and the
nozzle housing as instructed in the respective removal
sections.
3. Disconnect the motor leads and remove the motor
assembly.
4. Remove two air outlet packing and two screws from the
motor assembly to open.
5. Remove noise suppressor, motor cap, and motor flange.
Save these items to place them on the new motor.
3.9.2. Installation
1. Add a new seal impeller and body packing to the new
motor.
2. Assemble the noise suppressor, motor cap, and motor
flange onto new motor and place it into the air guide.
Secure with two screws and insert the two air outlet
14
MC-UG775-00
