-19-
Vacuum cleaner won’t run. 1. Unplugged at mains socket. 1. Plug in firmly, select the desired
setting on the touch control.
2. Tripped circuit breaker replace 2. Reset circuit breaker or fuse.
at household service panel.
3. Thermal protector tripped. 3. Allow vacuum cleaner to cool
40-50 minutes. (page 6)
4. Defective mains socket. 4. Check with a good appliance
or lamp. Have socket properly
serviced.
Poor job of dirt pick-up. 1. Full or clogged dust bag. 1. Change bag. (page 13)
2. Wrong pile height setting. 2. Adjust setting. (page 8)
3. Worn agitator. 3. Replace agitator. (page 17)
4. Clogged nozzle or bag holder. 4. See
CLOG REMOVAL
. (page 15)
5. Motor protection system 5. Check for clogs. (page 15)
activated.
6. Dirty secondary filter and/or 6. Clean or change filters.
exhaust filter. (page 14)
Vacuum cleaner picks up 1. Wrong pile height setting. 1. Adjust setting. (page 8)
moveable rugs or pushes too
hard.
Agitator does not turn. 1. Handle in full upright position. 1. Move handle from upright
position.
2. Belt protector tripped. 2. Reset belt protector. (page 6)
Sound changes. 1. New carpet fuzz clogged air path. 1. See
BYPASS VALVE
(page 6).
2. See
CLOG REMOVAL
(page 15).
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Before contacting your Panasonic service centre, check the following points:
NOTE:
Failure to correctly maintain your product, for example regular cleaning and unblocking, may result in a charge
if referred to a service agent for attention.
L) TROUBLESHOOTING
WARNING
Disconnect electrical supply before performing maintenance to the vacuum cleaner. Failure to do so could
result in electrical shock or personal injury.
Summary of Contents for MC-UG614
Page 23: ... 23 ...
