Panasonic MC-UG614, Operating Instructions Manual

Page: 14 / 24

-14-
D) EXHAUST FILTER REPLACEMENT
The HEPA exhaust filter must be replaced when
dirty. It should be replaced regularly depending on
use conditions.
The filter CANNOT be washed as it
will lose its dust trapping ability.
NOTE: See VACUUM CLEANER
CONSUMABLES/ACCESSORIES
(page 21) for the
exhaust filter number.
Remove exhaust filter cover by pressing the release
tab on the cover and rotating out from vacuum
cleaner.
Press
Filter
Cover
Release
Tab
Exhaust
Filter
AIRFL
OW
Place Seal Side
Against Vacuum
Cleaner Body
Exhaust
Filter Cover
1
2
1 2
1 1
Remove the filter cartridge from cover.
Place new filter cartridge into cover making sure that
airflow arrow on side of cartridge points into cover.
Place foam seal of filter against the vacuum cleaner
body.
Replace the exhaust filter cover by placing bottom
tabs in slots and rotating in until cover snaps into
place.
E) SECONDARY FILTER CLEANING
WARNING
Electrical Shock Hazard
Unplug mains lead from electrical socket. Do not
operate the vacuum cleaner without the
secondary filter. Be sure the filter is dry and
properly installed to prevent motor failure and/or
electrical shock.
Secondary
Filter
Dust Bag
Removed For Clarity
SECONDARY FILTER
Check secondary filter frequently and clean when
dirty.
If the secondary filter, located in the bottom of the dust
bag chamber, is dirty, remove it by pulling forward out
from under the ribs.
Wash the foam filter in warm soapy water, rinse and dry
thoroughly by squeezing the filter in your hand and
letting it air dry.
DO NOT wash in the dishwasher.
DO NOT install damp.
DO NOT use vacuum cleaner without secondary filter
and dust bag.
Replace the secondary filter by sliding it back into place
under the ribs in the dust bag chamber.
1 1