4.1. Nozzle cover
4.1.1. Removal
1. Release the nozzle cover by rotating the nozzle cover
retainers to the UNLOCK position.
2. Rotate upward on the nozzle cover to remove it from the
nozzle base.
4.1.2. Installation
1. To replace the nozzle cover, make sure the nozzle cover
retainers are in the UNLOCK position.
2. Hook the front of the nozzle cover onto the nozzle base and
rotate downward.
3. Once inplace, rotate the nozzle cover retainers to the LOCK
position.
4.2. Agitator / Belt Replacment
4.2.1. Removal
1. Remove the nozzle cover (see NOZZLE COVER
REMOVAL).
2. Disconnect power cord from electrical outlet. Press handle
release pedal and tilt the handle down so cleaner is lying
flat on the floor.
3. Position hands on agitator. If the belt is still attached to the
agitator, there will be tension on it.
4. Carefully lift the right end of the agitator and then lift the left
end.
5. Remove the belt from the motor drive shaft.
4.2.2. Installation
1. Reinstall new belt if necessary.
2. To replace the agitator, place the belt around the motor
shaft.
4 SERVICE PROCEDURES - NOZZLE
13
MC-GG529-00
