6. Check to see that the belt is centered on the belt pulley and
that the beater bar turns freely.
7. Replace nozzle cover.
3.3. Belt Replacement
3.3.1. Removal
1. Follow all of the removal instructions outlined in the Beater
Bar Assembly Replacement section.
3.3.2. Installation
1. Place the new belt around the motor shaft and follow the
installation instructions in the Beater Bar Assembly
Replacement section.
3.4. Handle Assembly Replacement
3.4.1. Removal
1. Remove the dust cover.
2. Press the handle release button and rotate to the down
position.
3. Disconnect the wire leads, wire connectors, and wire tie, if
present.
4. Remove cord stopper.
5. Remove the handle retention clip.
6. Remove handle from body by twisting and pulling away
from unit.
3.4.2. Installation
1. Insert handle into body in the down position, make sure
handle release button is in proper position.
2. Reinstall handle retention clip.
3. Replace cord stopper.
NOTE: Never reuse a cord stopper. Always install a new
cord stopper whenever the old one is removed.
4. Reconnect wire leads, wire connectors and wire tie if
needed.
5. Reinstall dust cover. Care should be taken not to pinch any
wires.
NOTE: For general servicing, it is necessary to eliminate
pinching of any wire during reassembly. After servicing
any electrical component or electrical enclosure, the unit
should be reassembled and checked for dielectric
breakdown or current leakage.
3.5. Handle Release Assembly
Replacement
3.5.1. Removal
1. Remove handle from unit as described above.
2. Separate the handle assembly by removing (14) fourteen
screws as illustrated in the Exploded View (Handle
Assembly)
3. Remove handle release button and spring.
3.5.2. Installation
1. Insert new button and spring if necessary. Make sure button
is seated properly in grooves on Handle A.
2. Assemble handle by reversing order above.
3.6. Mains Lead Assembly
Replacement
3.6.1. Removal
1. Refer to Handle Assembly Replacement Section.
2. With handle removed from body disassemble handle by
removing fourteen (14) screws. Refer to Handle Assembly
Exploded View.
3. Remove handle release button and spring.
4. Remove damaged lead.
12
MC-E4061-00
