3.1. Nozzle cover
3.1.1. Removal
1. Release the nozzle cover by rotating the nozzle cover
retainers to the UNLOCK position.
2. Rotate upward on the nozzle cover to remove it from the
nozzle base.
3.1.2. Installation
1. To replace the nozzle cover, make sure the nozzle cover
retainers are in the UNLOCK position.
2. Hook the front of the nozzle cover onto the nozzle base and
rotate downward.
3. Once inplace, rotate the nozzle cover retainers to the LOCK
position.
3.2. Beater Bar Assembly
Replacement
3.2.1. Removal
1. Remove the nozzle as outlined in the Nozzle cover section.
2. Disconnect mains lead from electrical outlet. Press handle
release pedal and tilt the handle down so cleaner is lying
flat on the floor.
3. Position hands on beater bar. If the belt is still attached to
the beater bar, there will be tension on it.
4. Carefully lift the right end of the beater bar and then lift the
left end.
5. Remove the belt from the motor drive shaft.
3.2.2. Installation
1. Reinstall new belt if necessary.
2. To replace the beater bar assembly, place the belt around
the motor shaft.
3. Loop the other end of the belt over the belt pulley on the
beater bar.
4. Insert the beater bar by placing the rounded portion of the
end caps down into the slots in the nozzle base.
5. Press firmly, checking to see that each end is completely
inserted.
3 REPLACEMENT INSTRUCTIONS
11
MC-E4061-00
