Enlarged view on the next page
Explanation label
10/100/1000BASE-T port
CONSOLE
9600.N.8.1(DTE)
SFP
▲
SFP
▼
15
13
11
9
16
14
12
10
RIGHT LED(ORANGE):LOOP DETECTION
7
5
3
1
8
6
4
2
ANY COL.
POWER
STATUS/ECO
GIGA
100M
FULL
LOOP HISTORY
Switch-M16eG
LED DISPLAY
CHANGE BUTTON
KEEP PRESSING 3SEC
ECO MODE ON/OFF
Part Names and Functions
10
2
Console port (RJ45)
LED display change button
Power port
MAC Address label
Ground terminal
Serial number label
Back panel
Front panel
SFP extension slot
Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
10/100/1000BASE-T port (ports 1–14)
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Switching
Hub can be connected to this port. Install the device so that the length of twisted
pair cable (CAT5e or above) becomes 100 m or less.
10/100/1000BASE-T port + SFP extension slot (ports 15,16)
Install SFP extension module here. (It becomes exclusive usage with twisted pair
port.)
When SFP extension slot is linked, the port is automatically switched to SFP
extension mode.
SFP port supports only the full duplex communication.
Console port
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
Power cord hook block
