Panasonic LX800H Series, Operating Instructions Manual

Page: 19 / 28

19
English
Either Bluetooth ® wireless technology or the infrared
communication function can be used for the
transmissions between the TV and the remote control.
Since voice controls (p. 21) use Bluetooth
® wireless
technology, the remote control needs to be registered
(paired) with the TV.
≥ Register (pair) the remote control during Initial Setup
(p. 22).
≥ If the remote control is not registered when you start
using voice controls, press the Google Assistant (voice
control) button to display the registration screen, then
follow the on-screen instructions to register.
If the registration screen doesn’t appear
“If registration fails” (p. 19)
≥
When registering, face the remote control at the
remote control signal receiver on the TV, within about
50 cm.
≥
Registration may not be completed correctly if the
batteries in the remote control are running low.
∫
If registration fails
If registration (pairing) is not completed properly, try
registering again.
1
Display the menu and select [Settings]
2
Select [Remote Control]
3
Select [Pairing Start]
The registration screen is displayed, so follow the on-
screen instructions to register.
∫
When the remote control does not respond
1
Press and hold the buttons shown below
simultaneously for about 3 seconds
2
Point the remote control at the remote control signal
receiver and follow the procedure below to deregister
(unpair) the remote control
[Settings] [Remote Control]
[Unpair]
3
Register (pair) the remote control again “If
registration fails” (p. 19)
≥
For details, refer to [eHELP] (Search by Purpose >
Settings > Remote Control).
≥ If the remote control is not registered (paired) with the
TV, they communicate via infrared. Face the remote
control at the TV’s remote control signal receiver for
operation when infrared communication is used.
Please note that voice controls will not be available.
≥ If the remote control is registered (paired) with the TV,
they communicate via Bluetooth
® . You will not need to
face the remote control at the TV’s remote control
signal receiver when Bluetooth
® communication is
used.
Please note, however, that when the LED is red
(standby) indicating that the TV is turned off, you will
need to face the remote control at the TV’s remote
control signal receiver for operation in order to turn on
the TV.
Registering the remote control
(supplied)
Remote control signal receiver
1
select
2
access
Settings
Note
TH-43_49_55_65LX800H_Eng_TQB4GA0092.book 19 ページ ２０２２年５月１７日 火曜日 午前９時４８分