file:///C|/U
...tabi/AppData/Local/Temp/Rar$EXa0.550/viewing/SGML_VIEW_DATA/ALL/DMC-FZ1000P/SVC/DSC1407014CE/doc/DSC1407014CE_10.xml[11/12/2018 5:16:37 PM]
3. Do not press any buttons/keys until the default menu (Refer to Fig.3-5) is displayed on the LCD monitor. Otherwise, adjustment data may not be stored
properly.
4. If the adjustment is interrupted accidentally, the alignment data may not be properly saved in the Flash-ROM.
Fig. 3-5
10.3.1.5 Finalizing the Adjustment
1.
Several adjustment fags can be reset (“F” into “0”) at the same time. In this case, when the adjustment has been completed, the screen will change
showing the adjustment for the next item until all reset items are completed.
Also, when the [ Shutter ] button is pressed, the screen jump to the next adjustment item.
2. To cancel the adjustment mode while in the process of performing the adjustment, follow this procedures.
3. Operate the following, when escaping the Electrical Adjustment mode on the way.
(1) Press “[ DISP. ] button”.
(2) Press “[ RIGHT ] of Cursor buttons”.
NOTE:
If adjustment is cancelled with above procedure, adjustment is not completed. Make sure to adjust it later.
10.3.2 Adjustment Specifcations
The following matrix table shows the relation between the replaced part and the Necessary Adjustment.
When a part is replaced, make sure to perform the necessary adjustment(s) in the order indicated.
The table below shows all the information necessary to perform each adjustment.