Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 91 / 240

91
4-1 I/O Interface Specification
The I/O terminal block and the I/O connector are available as the external control I/O interface of this product.
• I/O terminal block: Loaded with the basic input/output to control the laser marker.
• I/O connector: Loaded with the input/output for data configuration such as selecting a file number and the input/output
for the specific functions.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• Before using I/O, configure the system settings. Refer to “3-4-3 General settings before external control” (P.86).
X1
X2
X3
X4
X5
X6
X7
X8
X9
X10
X11
X12
X13
X14
X15
X16
X17
X18
X19
X20
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Y9
Y10
Y11
Y12
Y13
Y14
Y15
Y16
Y17
Y18
Y19
Y20
2
39
1
40
X1
X2
X3
X4
X5
X6
X7
X8
X9
X10
X11
X12
X13
X14
X15
X16
X17
X18
X19
X20
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Y9
Y10
Y11
Y12
Y13
Y14
Y15
Y16
Y17
Y18
Y19
Y20
Rear of controller
I/O terminal block
I/O connector
(Laser marker)
Hook
The I/O terminal block can be
removed by holding down the
hooks.
„
Connector specifications and models
Connector position Connector specifications Model Manufacturer name
I/O terminal
block
On the laser
marker side
Dedicated connector 15EDGRHCM-THR-3.5-40P-1 Degson Electronics
Co., Ltd
User side Accessories: 15EDGKNHG-
3.5-40P-14-00A
I/O Connector On the laser
marker side
MIL connector
40-pin/male
XG4A-4034 OMRON Corporation
User side MIL connector
40-pin/female
Accessories: XG4M-4030-T
„
Wiring of input/output lines
Install one of the ferrite cores included in this product to the wirings from the I/O
terminal and another one to the lines from the I/O connector.
If the diameter of the ferrite core is too large, turn the I/O lines around the ferrite core
as shown in the figure.
Rear of controller
Ferrite cores
ME-LPRH-SM-3