Panasonic KY-A227D, Operating Instructions Manual

Page: 11 / 12

必要
な
と
き
Care
20 21
Troubleshooting
Symptom Probable cause
■
Sound and noise
Noise is heard
while heating.
• Various resonant sounds may be heard depending on the
type of cookware. You may feel small vibration when you
hold the handle, or the cookware may slightly move.
→ This is not a malfunction. Moving the cookware
slightly or replacing it may stop the sound.
• If the cookware is removed while heating, a short
metallic sound may be heard.
Even after the
main power
switch is turned
off, noise from the
fan is still heard.
• The cooling fan is operating because the inside of the
appliance is still hot.
( As the appliance cools down, it will automatically
stop.)
■
Heating power
The heating
power of the IH
heater seems
weaker.
• Overheating prevention function
If the bottom of the cookware overheats, for example, by
preheating too long, the heating power will be reduced
automatically without changing the heat level indication.
( The heating power returns to normal after the
cookware cools down.)
• Cookware, such as ceramic and earthenware pots,
which cause the IH heater to overheat are used.
→ Do not use ceramic ware and earthenware even if
they are made for induction heating.
When both the right
and left IH heaters are
used simultaneously,
• The heating
power is reduced
or a lower heat
level is indicated.
• The heat level
cannot be
increased.
• The heating power is automatically controlled so that
overall power consumption does not exceed the limit.
(P.23)
* The heat level may decrease automatically.
Even after touching , the level may not increase
and the appliance may beep.
Error Indications
Indication Probable cause
Filter clog detection
• The intake or exhaust vent is clogged with dust,
etc.
→ Remove any blockage.
or
Empty pot auto shutoff
• An empty pot has been heated.
→ Put ingredients into the pot and touch the key
again.
* This function may not operate properly depending
on the type of pot, or if the heat level is low.
Top plate high
temperature detection
(for congee)
• “Congee menu” was used while the top plate is
hot.
• An empty pot has been heated with “Congee
menu”.
→ After the top plate cools down, touch the key
again.
If any of the following error indications appears, check the cause and deal with it.
After the cause is eliminated, touch or . Then, the error indication
will disappear.
• You can also clear the error with .