24
Troubleshooting
Problem
The unit does not work.
An alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
You cannot program items
such as the dialing mode.
Previously programmed
information is erased.
You cannot store a phone
number in memory.
Remedy
•
Check the settings (p. 7–11).
•
Charge the battery fully (p. 8).
•
Clean the charge contacts and charge
again (p. 9).
•
Install the battery properly (p. 8).
•
Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
•
Re-install the battery and place the
handset on the base unit (p. 22). Try
again.
•
You are too far from the base unit. Move
closer and try again.
•
Place the handset on the base unit and
try again.
•
Plug in the AC adaptor.
•
Raise the base unit antenna.
•
Locate the handset and the base unit
away from other electrical appliances
(p. 3).
•
Move closer to the base unit.
•
Raise the base unit antenna.
•
Press
Ü
to select a clearer channel in
the talk or speakerphone mode.
•
The ringer volume is set to OFF. Set to
HIGH or LOW (p. 11).
•
Programming is not possible while the
unit is in the talk mode.
•
Do not pause for over 60 seconds while
programming.
•
Move closer to the base unit.
•
If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•
You cannot store a number while the
unit is in the talk mode.
•
Do not pause for over 60 seconds while
storing.
