Panasonic KX-UT670, Administrator'S Manual

Page: 102 / 250

Value Range
1 or 2 (
´
10 ms)
Note
•
This setting is subject to the following conditions:
–
This value must be less than or equal to [Initial Delay]
–
This value must be less than [Maximum Delay]
–
[Maximum Delay] must be greater than [Initial Delay]
Default Value
2 (
´
10 ms)
Configuration File Reference MIN_DELAY_n (Page 179)
Initial Delay
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range 1–7 (
´
10 ms)
Note
•
This setting is subject to the following conditions:
–
This value must be greater than or equal to [Minimum
Delay]
–
This value must be less than [Maximum Delay]
Default Value
2 (
´
10 ms)
Configuration File Reference NOM_DELAY_n (Page 180)
4.6.4.4 DTMF
DTMF Type
Description Selects the method for transmitting DTMF (Dual Tone Multi-Frequency)
tones.
Value Range •
Outband
•
Inband
Note
•
If you select [Outband] , DTMF tones will be sent through SDP
(Session Description Protocol), compliant with RFC 2833. If you
select
[Inband] , DTMF tones will be encoded in the RTP
stream.
Default Value Outband
Configuration File Reference OUTBANDDTMF_n (Page 182)
DTMF Relay
Description Selects whether DTMF tones are sent in the SIP INFO message.
102 Administrator Guide Document Version 2012-07
Section 4 Web User Interface Programming