Panasonic KX-TVM200, Programming Manual

Page: 120 / 200

2.5 System Parameters
120 Programming Guide
Value Range
Max. 16 digits consisting of 0–9, , #, and A–D
Confirmation
Specifies the DTMF signal used to indicate a confirmation tone. Sent to the VPS when the Message
Waiting Lamp was successfully turned on or off.
Value Range
Max. 16 digits consisting of 0–9, , #, and A–D
Disconnect
Specifies the DTMF signal used to indicate a disconnect tone. Sent to the VPS when the other party
goes on-hook.
Value Range
Max. 16 digits consisting of 0–9, , #, and A–D
Digit Translation Table
Use the Digit Translation Table to translate the Follow On ID Signal from the PBX into the proper
codes for the VPS. This translation table is only effective for the incoming signal.
Inter-Digit Timeout
Defines the incoming signal interval (Follow on ID). The Digit Translation Table is translated by a
series of signals received within the specified time period.
Value Range
1 s–4 s
Translation Table (Table 1–Table 8)
Follow the steps below to edit the Translation Table
1.
Click Click to edit….
2.
Enter the digits sent from the PBX under "Input Digit" and the corresponding digits received by
the VPS under "Output Digit" in the Translation Table dialogue box.
3.
Click OK.
Input/Output digit
Defines the input or output digit for the Digit Translation Table. Do not assign more than 1 code to an
incoming signal. If this occurs, the VPS will take the first assignment.
Note
In each table, the number of "K" used for the Input digit must be the same as the one used for
the Output digit.