Panasonic KX-TVM200, Programming Manual

Page: 118 / 200

2.5 System Parameters
118 Programming Guide
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialling
1–9, 0, , #: Dial Code
Receiving Caller ID
Enables or disables the VPS to receive Caller ID from the PBX while receiving a call.
Value Range
Disable, Enable
Waiting Time for Receiving Caller ID
Specifies the length of time that the VPS waits before receiving Caller ID from the PBX. This
parameter is needed only when "Enable" is selected in "Receiving Caller ID".
Value Range
0 s–10 s
Inband Signalling
Set these parameters only if the Integration Mode is set to "Inband" under "PBX Environment". If the
PBX type is set to a KX-T series PBX, the Inband Signalling parameters will be automatically set to
the default codes for the KX-T series PBX.
Note
• Default values below vary depending on the setting of "PBX type" in "PBX Environment".
Ringback
Specifies the DTMF signal used to indicate a ringback tone. Sent to the VPS when the extension
dialled is ringing.
Value Range
Max. 16 digits consisting of 0–9, , #, and A–D
Busy
Specifies the DTMF signal used to indicate a busy tone. Sent to the VPS when the called extension
is ringing.